Bosch Rexroth Tightening System 350 - Interface Standards

198/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.1.1 Interface standards
In the Tightening System 350, the data services can be transferred to output devices or devices for further
processing or storage via interfaces.
As of version V2.500 of the Rexroth Tightening System 350, the following protocols can be used:
Further information can be found in the chapters on the respective data service.
CAQTNG will no longer be supported as of version V2.500 of the Rexroth Tightening System 350.
Table 6–1: Interfaces in the Tightening System 350
Interface KE SE352M CS
– Serial interfaces X3C1 X X
– Ethernet interface X7E1
–FTP X X
1
1 Not available with CS351S-D NK and CS351E-D NK
– Rexroth Open Protocol (Rexroth OP, Rexroth
OP-Ford, Rexroth OP-BMW)
XX
1
– VW-XML Protocol X X
1
– Rexroth IPM Protocol X X
1
– HTTP Protocol X X
1
– PFCS Protocol X X
1
– PFCS 2-Port Protocol X X
1
– QDA Protocol X X
1
– PLUS Protocol X X
1
– RPA Protocol
2
2 Only available with KE350G IL and CS351...IL
XX
–A slot interface:
– IMdev (DeviceNet interface, based on the CAN bus
standard)
XX
3
3 Not available with CS351S-D NK, CS351E-D NK and CC-CS351E-D
– IMpdp (PROFIBUS DP according to EN 50 170) X X
3
– IMpnio (PROFINET IO) X X
3
– IMpnio2 (PROFINET IO) X X
3
– IMenip (EtherNet/IP) X X
3
– IMenip2 (EtherNet/IP) X X
3
– IMmtcp (ModbusTCP) X X
3
– IMecat (EtherCAT) X X
3
–B slot interface
*
:
– IM24V (24V interface)
XXX
4
4 Not available with CS351S-G+ and CS351E-G+
* Simple input and output signals can be transferred via the IM24V interface. The transferred signals are
not checked for plausibility or read back.