32/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
2.6.8 Protection against pressurized lines
According to the specifications in the planning documents, liquid-cooled and forced-air-cooled motors
and drive controllers, as well as forced-air-driven leads, may be supplied with external, pressurized media
such as compressed air, hydraulic fluid, coolant, and coolant lubricant. In this case, incorrect handling of
external supply systems, supply lines, or connections may lead to injuries or damage to equipment.
CAUTION
Risk of injury due to improper handling of pressurized lines!
The improper handling of pressurized lines may cause explosions that can again lead to injuries.
Never attempt to disconnect, open, or cut pressurized lines (risk of explosion).
Observe the operating instructions from the respective manufacturer.
Discharge the pressure and medium from lines before disassembly.
Use suitable protective equipment (for example, protective goggles, safety shoes, protective
gloves).
Any fluids that have leaked onto the floor must be wiped up immediately.
Environmental protection and disposal: The media used to operate this product may be harmful to the
environment. Dispose of toxic media separately from other waste. Observe the national regulations of the
country where the product is installed.
To Next Page
Loading...
