Bosch Rexroth Tightening System 350 - Bypassing a Spindle with Ch X.y Byps or Via the Operating Program; Behavior of FC Rdy and FO X Rdy in Bypass Mode; NOK Lock of a Tightening Application and Acknowledgement with FO X Nokac

3 608 878 300 Tightening Technology | Bosch Rexroth AG 171/641
System 350 | 3 608 878 300/2019-03
5.4.17 Bypassing a spindle with Ch x.y Byps or via the operating program
(1) Input, (2) Output
5.4.18 Behavior of FC Rdy and FO x Rdy in ByPass mode
When the ByPass functionality (rising edge of the ByPass signal) is activated, the Ready signal of the
channel becomes 0 while the BypsAc acknowledgement signal becomes 1. The Ready signal of the
FC_Rdy cell and the Ready signal of the application involved, FO_Rdy_x remain 1.
If the channel deactivated with ByPass = 1 is reactivated (falling edge of the ByPass signal), the BypsAc
acknowledgement signals becomes 0. The Ready signal of the FC_Rdy cell becomes 0 and returns to 1
once all channels signal Ready. The Ready signal of the FO_Rdy_x applications is undefined as long as
the Ready signal of the FC_Rdy cell = 0.
5.4.19 NOK lock of a tightening application and acknowledgement with FO x NOKAc
(1) Input, (2) Output
__________/ǦǦǦǦǦǦǦǦǦ\___________________ ByPass
ǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦ\____/ǦǦǦǦǦǦǦǦǦ FC_Rdy
ǦǦǦǦǦǦǦǦǦǦ\___________________/ǦǦǦǦǦǦǦǦǦ Chx.yRdy
__________ǦǦǦǦǦǦǦǦǦǦǦǦǦǦ\______________ Chx.yBypsAck
ǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦǦ FO_Rdy