Bosch Rexroth Tightening System 350 - Operating the Modular System

3 608 878 300 Tightening Technology | Bosch Rexroth AG 585/641
System 350 | 3 608 878 300/2019-03
7.6 Operating the Modular System
Multiple tightening channels are usually operated in the modular system. The KE controls the control units
of the tightening channels.
7.6.1 General information on the configuration
The KE configuration includes setting the parameters of all the components in the KE. The configuration
window (see Figure 7–28) opens when the following menu items have been selected:
• System KE configuration in online mode (see page 586) and/or
• File
 New KE configuration in offline mode (see page 603).
Layout of the
configuration window
The configuration window in the BS350 displays the following (see Figure 7–28, from left to right):
• The front view of the KE
• The KE configuration with its available interfaces subdivided into 4 columns:
– Name
– Symbol
– Parameter
–Notes
Fig. 7–28: Configuration loaded online using the KE350G as an example
The configuration has to be sent to the corresponding tightening channel upon creation. The same is
compared to the actual configuration (actual equipment) of the tightening channel. After the configuration
has been sent, errors (e.g. configuration conflicts) will be displayed in the configuration window.
Symbol
Configuration fields
KE front view
Name Parameter Note