612/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
However, if the tightening channel is designed with tightening spindle without saved configuration or if
the saved data are invalid, the channel has to be re-configured in the operating system BS350 .
Afterwards, the data have to be sent to the controller. Additionally, the error message 1111 "Channel
configuration missing" is issued. This procedure is identical to the behavior known from previous
versions when there was no configuration saved to the controller.
Deleting channel
configuration
Use Data Delete SE/CS Configuration in the BS350, to delete the saved channel and spindle
configuration data on the tightening controller. Furthermore, this function deletes the spindle
configuration data in the extended memory of the DMC of the tightening spindle.
7.7.1 Compact system
All hand-held nutrunners are recognized automatically (with the exception of VarioLine). As a result, an
operating system is not always required to configure and program the tightening channel, depending on
the compact system used:
• With the CS351E-G or CS351E-G IL compact system, you can use the TFT- display instead.
• With the CS351E-D or CS351E-DIL Compact System, a BS350 operating system is required.
NOTICE
Incorrect channel configuration
By replacing mechanical components or components with integrated measurement transducer
(DMC, VMC, WMC), the saved channel configuration may deviate from the actual configuration.
Thus, erroneous tightenings may be the result.
After having replaced mechanical components or components with integrated measurement
transducer, always re-configure the tightening channel. Use the operating program BS350.
Finally, save this new configuration to the hand-held nutrunner or tightening spindle, see Saved
("automatic") channel configuration on page 611.
NOTICE
Adaptes spindle component efficiency
The efficiency of the spindle components were partially optimized in the BS350 V2.300 data base. If
the channel configurations created wit these spindle components are sent to the tightening controller,
the physical torques of the bolt may change slightly with respect to the "old" channel configuration,
data base < V2.300.
To Next Page
Loading...
