Bosch Rexroth Tightening System 350 - Operating the compact system

3 608 878 300 Tightening Technology | Bosch Rexroth AG 549/641
System 350 | 3 608 878 300/2019-03
7.5 Operating the compact system
7.5.1 General information on the configuration
The configuration of a tightening channel with BS350 includes logical linkage and parameter assignment
of all electronic and mechanical components involved in the tightening channel. The configuration window
(see Figure 7–13) opens when the following menu items have been selected:
• System  Tightening channel configuration in online mode (see page 550) and/or
• File  New  Tightening channel configuration in offline mode (see page 576).
Layout of the
configuration window
The configuration window of the BS350 displays (see Figure 7–13, from left to right):
• Component selection
• Configuration of the tightening channel as logically linked components subdivided into
four columns (from left to right):
– Name
– Symbol
– Parameter
–Notes
– Global parameters
Fig. 7–13: Layout of the tightening channel configuration window
The configuration has to be sent to the corresponding tightening channel upon creation. The same is
compared to the actual configuration (actual equipment) of the tightening channel. After the configuration
has been sent, errors (e.g. configuration conflicts) will be displayed in the configuration window.
Global parameters Configuration fields Component selection
Name Symbol Parameter Notes