Bosch Rexroth Tightening System 350 - Motor-Breaker; Switching on the Tightening Cell

534/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.2.7 Motor-breaker
in chapter Construction guidelines from page 59.
7.2.8 Switching on the tightening cell
7.2.8.1 Compact system
LED displays
Fig. 7–9: LED on the front
NOTICE
Overvoltage
Components may be damaged
 The CS on/off switch may only be switched on once all the cables have been connected and
checked for proper fit.
Table 7–6: LED modes
LED Display Diagnosis
Off No power supply or low-voltage power supply
available
Blue Power supply and low-voltage power supply
available
Green Ready for operation
Green, flashing Sequence control active, not ready for operation,
no system error
Red, flashing System error
OK/NOK Green Tightening case evaluation: OK
Red, flashing Tightening case evaluation: NOK
Off Motor contactor not operated
Green Motor contactor operated
Red/green, flashing Servo amplifier initialization
Red Motor contactor error
FG Green Servo amplifier release
Off No servo amplifier release
RUN/STOP
(only for
CS... IL)
Green IndraLogic running
Red IndraLogic stopped
ERROR
(only for
CS... IL)
Red, flashing IndraLogic error