Bosch Rexroth Tightening System 350 - Recognition of Play at Start Switch; Controlling the Ergospin by an External Controller

180/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
5.6.4 Recognition of "play at start switch"
This function is active only if hand-held nutrunner function is active.
(1)
Input, (2) Output
No evaluation (OK = NOK = 0) is implemented.
5.6.5 Controlling the ErgoSpin by an external controller
The Cw PLC signal is applied to the ErgoSpin start switch. The external controller sets the LEDs on the
ErgoSpin and controls the tightening operation.
The normal sequence expects that the user pushes the start switch while tightening is in progress. While
the start switch is pushed and held, several programs can run one after the other. The StartBn signal
transmits the status of the start switch on the hand-held nutrunner to the external controller.