Bosch Rexroth Tightening System 350 - Configuration SE;CS PLC Assignment Table

580/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.5.4.3 Sending/saving data
Tightening programs have to be sent to the tightening controller before they can be used. They can also
be stored as files on the PC (see Sending and saving (page 542)).
7.5.5 Configuration SE/CS PLC assignment table
The PLC assignment table defines the assignment of the control signals to the tightening controller's
physical interfaces. The tightening controller can be integrated into a system sequence with these control
signals. The following number of inputs and outputs are available on the interfaces:
A maximum of 256 input and output signals can be used.
With automatic channel configuration, the PLC assignment table is created in accordance with the
presettings when the compact system is commissioned with the ErgoSpin. It can be loaded from the
compact system by selecting System  SE/CS PLC assignment table.
Send the preset PLC assignment table to the tightening controller; it can also be stored as a file on the
PC (see Sending and saving (page 542)).
Table 7–24: Number of inputs and outputs
System component Number of inputs/outputs SE Number of inputs/outputs CS
ErgoSpin 4/0 4/0
IMpdp – 16 to 64/16 to 64
IMdev – 16 to 64/16 to 64
IMpnio, IMpnio2 – 0 to 64/0 to 64
IMenip, IMenip2 – 16 to 64/16 to 64
IMmtcp – 16 to 64/16 to 64
IMecat – 16 to 64/16 to 64
IM24V 5/6 10/13
HMI – 8/0
HVO – 8/8
IL – 32/32
OP – 33/24
XML – 22/25
Information on the configuration of the PLC assignment table can be found in section „PLC signals“ on
page 123.
The detailed description of the control signals can be found in chapter Control signals from page 121.