622/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.7.4 Configuring the optional additional module barcode scanner
The Configuring the tightening channel does not differ between ErgoSpin hand-held nutrunners with or
without optional additional module "barcode scanner". The only distinctive feature is that hand-held
nutrunners with barcode scanners have a PE number.
The barcode scanner within the hand-held nutrunner can be selected as ID code source (see „Selection
of the source for ID-codes“ on page 200) and can be configured manually. The barcode scanner settings
can be modified using the following:
•CS/KE: System
Tightening cell data Scanner Scanner in the hand-held nutrunner
•SE352M: System SE data Scanner Scanner in the hand-held nutrunner
The following setting options are available:
• Activate or deactivate barcode scanner
• Valid (permitted) barcode types, the length of the same, and whether the corresponding barcode
type is active
There are several options for the length of the corresponding barcode:
–Entry of a fixed length, e.g. „12“
–Entry of 2 fixed lengths, e.g. „4;8“
–Entry of a length range, e.g. „3–9“
– No length restriction, i.e. "all" or ""
• Barcode-specific options, such as the "Security Level"
• Time-dependent parameters, i.e.
– Activation time
– Release time
–Signal time
– Delay during continuous operation
Table 7–40 shows the as-delivered-state of this time-dependent parameters.
After configuration of the barcode scanner within the ErgoSpin hand-held nutrunner, there are the
following options:
• Updating the configuration data
• Sending the configuration data to the hand-held nutrunner
The optional barcode scanner for the versions SlimLine, GripLine, and VarioLine of the ErgoSpin hand-
held nutrunner is available as of V2.200 of the Rexroth Tightening System 350.
To Next Page
Loading...
