Bosch Rexroth Tightening System 350 - Page 621

3 608 878 300 Tightening Technology | Bosch Rexroth AG 621/641
System 350 | 3 608 878 300/2019-03
Fig. 7–43: Tightening program comparison
The changed program is assigned to the tightening controller or ErgoSpin with the arrow buttons >> and
<<. You must then send this assignment to the tightening system using Send.
Tightening programs ErgoSpin or Tightening programs SE/CS opens the tightening programs from
the ErgoSpin or the tightening controller for editing.
7.7.3.5 Changing tightening programs
The parameters of the tightening program can be changed in the BS350 operating system or via the
TFT-display. You must then send the tightening program to the tightening controller.