3 608 878 300 Tightening Technology | Bosch Rexroth AG 225/641
System 350 | 3 608 878 300/2019-03
6.2.3 Formats of the results output
To set the desired output format:
1. In the BS350 operating system, click System Tightening cell data.
2. Click FTP.
3. Select the Results index card.
The index card is divided as follows:
Fig. 6–15: Configuration of formats of the results output (FTP)
6.2.3.1 Transfer settings
In the Transfer menu, it is determined how the results output will be processed in the tightening process.
The following settings are possible:
• After process end (see page 240)
• Before process end (see page 240)
• Single session (see page 240)
• Timeout: The value set here defines how long (in seconds) the FTP client should try to establish a
connection to the server (FTPHookup) before the signals are generated and a corresponding entry
is made in the error list. The signals generated are: FtpF = 1 and NF = 0 (with compact system) or
KE FtpF = 1 and KE NF = 0 (with modular system). As long as the signal NF = 0 (with CS351) or
KE NF = 0 (with KE350) is set, the tightening system is not ready to perform other tightening
processes (a list of the corresponding system errors can be found on page 258). FtpF = 1 / KE FtpF
= 1 and NF / KE NF are reset via the ResF and KE ResF signals, respectively.
1 Transfer settings
2 Results selection
3Output formats
With the setting "Before process end", the tightening results data are lost if it is not possible to transfer
via Ethernet.
To Next Page
Loading...
