7 Basic commissioning
This document explains how to commission the Rexroth Tightening System 350 with
the sequence test. This includes commissioning the CS351 compact system with
ErgoSpin hand-held nutrunner or a tightening spindle, as well as commissioning the
modular system with a tightening spindle. Commissioning primarily consists of
system construction, setting up the programming interface (Ethernet or USB),
configuration of the tightening channel, and creating tightening programs with the
BS350 operating system. The connection of the tightening cell to a partner controller
(PLC) is not the subject of this chapter.
For information on the integrated logic, see in the "Project planning" documentation
of the Rexroth Tightening System 350.
• Overview (page 520)
• Assembling the tightening cell (page 526)
• Connecting the PC for programming (page 536)
• Sending and saving (page 542)
• Operating the compact system (page 549)
• Operating the Modular System (page 585)
• Saved ("automatic") channel configuration (page 611)
• Special operating features of the hand-held nutrunner ErgoSpin/CC-ErgoSpin
(page 626)
• Special characteristics of Nexo cordless Wi-Fi nutrunner operation (page 636)
To Next Page
Loading...
