Bosch Rexroth Tightening System 350 - Assignment of XML Protocol to Toolsnet Protocol; Error Analysis and Treatment

3 608 878 300 Tightening Technology | Bosch Rexroth AG 329/641
System 350 | 3 608 878 300/2019-03
6.6.6 Assignment of XML Protocol to ToolsNet Protocol
6.6.7 Error analysis and treatment
Verify at regular intervals whether tightening results have been buffered.
Buffered tightening results can be found in the directory specified in the configuration file (section
[Global], parameter File Queue Dir).
 If (non-transmitted) files are available there, check the settings for the ToolsNet gateway and/or the
ToolsNet server in the configuration file.
 If no files are available there, there might be a problem in the settings for the ToolsNet gateway and/
or the BS350 operating system in the event of an error.
Verify at regular intervals whether logging files have been created. Logging files are created in the event
of an error. Logging files can be found in the directory specified in the configuration file (section [Global],
parameter Log Path).
Table 6–65: Assignment of XML Protocol to ToolsNet Protocol
ToolsNet-Protokoll tag XML tag
Timestamp DAT + TIM
Rundown sequence number CSA
VIN PI1
Spindle number KNR
Spindle serial number SID
Program number PRG
Overall Status TSC
Torque low limit T-
Final torque TI
Torque status TSC
Torque high limit T+
Angle low limit W-
Final angle WI
Angle status TSC
Angle high limit W+
Time status TSC
Note on the rounding of set and actual values
Angle values and torque values related to data output from the Tightening System 350 are rounded to
one decimal place for transfer to the ToolsNet server. This may result in an error evaluation on the
ToolsNet server. Please note that rounded values may result in error evaluations.