576/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.5.3 Offline configuration:
In addition to the online configuration, the BS350 also allows for channel configurations to be generated
even if no tightening channel is connected. This may be helpful if, e.g., the channel configuration to be
generated is known before commissioning and can be done as preparatory work.
To generate a new configuration file in offline mode
In BS350 click File New Tightening channel configuration.
When generating a channel configuration offline, all the electronic and mechanical components have to
be added to the configuration file manually.
To add a component manually:
Click the empty symbol field and then select a permitted component from the component selection
(see Figure 7–22)
The global parameters are set in accordance with the online configuration (see Configuration example
(page 556)).
Fig. 7–22: Offline configuration of a tightening channel
The configuration of the tightening channel can be stored as a file on the PC (see Sending and saving
(page 542)). It must be sent to the tightening controller before commissioning the tightening channel.
Only those components permitted in the configuration sequence are highlighted for selection, those not
allowed are grayed out! This ensures that the linked components in the configuration sequence are
plausible.
Permitted component Empty symbol field
Tightening channel configurations created offline which contain either an ErgoSpin hand-held nutrunner
of type VarioLine (ESV) or of type pistol grip nutrunner (ESM) are not accepted by the tightening
controller.
In this context, see the information in section „Channel configuration created offline with an ErgoSpin
VarioLine (ESV) or pistol grip nutrunner (ESM)“ on page 617.
To Next Page
Loading...
