EasyManua.ls Logo

Bosch Rexroth Tightening System 350 - Formats of the Results Output

Bosch Rexroth Tightening System 350
641 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
294/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.4.4 Formats of the results output
6.4.4.1 Parameters/values in the output
Available results values for application results
The results of tightening applications are comprised of the application result (in accordance with Table
6–49) and a channel result for each participating tightening channel (in accordance with Table 3).
Available results values for single-channel tightenings and channel results within an application result
The values listed in Table 6–50 are available for the results from single-channel tightening processes and
channel results within a tightening application.
Table 6–49 shows all the possible results for a tightening application. The results to be output are defined
in the BS350 operating program (see page 301).
Table 6–49: Results values of tightening applications during output
Name Meaning Length in
bytes
Format Comments Example
FO:Application block 1 Int8 3
FO:Application Application number 1 Int8 47
FO:Application name 1-20 ASCII Filled with space
characters, if
necessary
Cylinder head 5 cyl.
FO:ID code Application ID code 1-64 ASCII TKZ 7688-A
FO:C. no. KE KE serial number 4 INT32 861000000
FO:Date Date and time 4 INT32 1098773240
1
FO:Result Application results 1 Int8 (1 or -1) 1 = OK, -1 = NOK
FO:Quality code 5 ASCII With leading space
characters, if
necessary
____1 = all OK
FO:Stopped by Switch-off criterion 2 ASCII _0
FO:Number of tightening
positions
1Int8 5
1 Date and time are indicated in seconds counted since 1. 1. 1970, 12:00:00 a.m.
The number 1098773240 corresponds to the following time: Tuesday, 10/26/2004, 6:47:20 a.m.
Table 6–50 shows all the possible results for tightenings. The results to be output are defined in the
BS350 operating system (see sections 6.4.4.4 and 6.4.4.5).
If a docu step is not run through or if the tightening channel is in bypass (see "Project planning"
documentation of the Rexroth Tightening System 350), the value 0@ will always be output as the step
number for this/these docu level(s).

Table of Contents

Related product manuals