636/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.9 Special characteristics of Nexo cordless Wi-Fi nutrunner operation
This section describes the characteristics of the operation of the Nexo cordless Wi-Fi nutrunner.
Configuration files
• *.ini configuration file:
The configuration file contains the IP address of the Nexo cordless Wi-Fi nutrunner to be connected
as well as the field bus assignment (PLC) as default setting. All cordless Wi-Fi nutrunners are
configured identically. Configuration is carried out using the BS350.
• Sys350_Fieldbus_Nexo.zip zip file
The zip file is an IndraWorks archive. Supported IndraWorks versions (10, 11, 12).
The zip file contains the IL program for the Nexo protocol conversion. The file can be found in the
directory Miscellaneous IL-Examples on the system stick.
Nexo configuration in BS350
Online configuration
Click on Extras Nexo configuration.
Offline configuration
Click on File New Nexo configuration.
After starting, the Nexo configuration view is displayed. By default, the entry New Nexo with the IP
address 0.0.0.0 is displayed.
Fig. 7–52: Nexo configuration
The Nexo cordless Wi-Fi nutrunner can be connected from V2.300 of the Rexroth Tightening System 350.
Please find information on the Rexroth Nexo cordless Wi-Fi nutrunner in the "Nexo" documentation.
To Next Page
Loading...
