3 608 878 300 Tightening Technology | Bosch Rexroth AG 635/641
System 350 | 3 608 878 300/2019-03
Other deviations of the CC version in the BS350 standard operating system
Fig. 7–51: CC-CS351 configuration
• With the CC-CS351, module slot A is not displayed in the tightening channel configuration.
Interface modules in slot A are not supported by the channel configuration. For this reason, all field
bus functions are disabled.
• With the CC-CS351, the "motor current transducer function" is set to primary and cannot be
adjusted.
The auto configuration sets the transducer function to "primary transducer" for the servo amplifier
and to "off" for the hand-held nutrunner. This cannot be changed. This is automatically done for
unconfigured systems following a restart.
• The CC-ErgoSpin does not support the function "transducer test".
The "standard" ErgoSpin executes the transducer test outside of the tightening. The ErgoSpin reads
measured values from the measurement transducer.
The CC-ErgoSpin records measured values via the motor current when turning the spindle. For
operator safety reasons, this is not possible in the transducer test.
To Next Page
Loading...
