3 608 878 300 Tightening Technology | Bosch Rexroth AG 541/641
System 350 | 3 608 878 300/2019-03
7.3.5 Logging in to the tightening system (password entry)
In order to be able to change tightening programs and configurations, the user must be logged in to the
tightening system using his user name and password.
To log in to the tightening system:
1. Click the symbol or
click Administration Log ON/OFF or
press the [F3] button on the keyboard.
2. Enter the password Robert and confirm with OK.
Fig. 7–11: User name Bosch, password Robert
The status Log ON is shown in the status bar.
Period of the active connection
If you access the KE communication unit or the CS351 compact system using the BS350 operating
system, the connection is automatically disconnected after 15 minutes.
The user does not have to be logged in to the system to query configurations, results, error lists, etc.
As of Rexroth Tightening System 350 version V2.600, selection between the standard authorization
concept and a new authorization concept is possible. Depending on the selection, additional settings can
be made. Refer to"Project planning" documentation of the Rexroth Tightening System 350.
Information on the password change can be found in the "Project planning" documentation of the Rexroth
Tightening System 350.
To Next Page
Loading...
