3 608 878 300 Tightening Technology | Bosch Rexroth AG 539/641
System 350 | 3 608 878 300/2019-03
7.3.4 Setting up the programming interface
7.3.4.1 USB interface
The USB interface drivers must be installed separately. The necessary files and instructions for this can
be found on the USB stick provided with the tightening system (hereafter referred to as the
"system stick").
To select the USB interface:
1. Make sure that the PC is connected to the compact system via the USB cable (interface X3U3 at the
front).
2. Click PC Interface in the BS350 operating system.
3. Select the USB interface.
4. Click OK to accept the setting.
5. Click System test Tightening channel info to test the connection.
7.3.4.2 Ethernet interface
In order to operate the tightening system via Ethernet, the PC has to be equipped with an Ethernet
interface card for network operation.
The Ethernet interface in the compact system has the following settings by default:
• IP address: 192.168.1.1
• Subnet mask: 255.255.255.0
• Host name: cell
The rest of the settings are either 0.0.0.0 or empty.
If the connection is not established, you can reset all connection parameters without closing the BS350.
Proceed as follows:
Disconnect the USB cable from the interface.
Reinsert the USB cable in the interface.
Go to the PC/PC interface window and click the Reset button.
If the connection is not established, you can reset all connection parameters and close any open
connections, without closing the BS350. Proceed as follows:
Go to the PC/PC interface window and click the Reset button.
To Next Page
Loading...
