164/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
5.4.3 Normal sequence of a tightening application (OK tightening)
(1) Input, (2) Output
There is a delay between the OK/NOK an CyCmp signals during results output, e.g. via the printer
interface. OK/NOK comes at the end of the tightening and CyCmp only after the data output. This delay
depends on the data output and can last from several 100 ms up to several seconds. For the behavior of
CyCmp in an application, refer to table on page 143.
5.4.4 Normal sequence of an already selected tightening application
(1) Input, (2) Output
To Next Page
Loading...
