22/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
2.2.2 Application areas
The Rexroth tightening system is a system used to perform, document, and analyze tightenings in
accordance with freely programmable sequences.
2.3 Improper use
Use of the Rexroth tightening system and components for any application not listed herein, or under
operating conditions other than those described in the respective documentation and technical
information, is considered improper use.
The Rexroth tightening system and components may not be used:
• If subjected to operating conditions that do not fulfill the specified ambient conditions. Operation is
forbidden e.g. under water, at high air humidity, under extreme temperature fluctuations, or under
extreme maximum temperatures.
• If used in applications that have not been explicitly approved by Bosch Rexroth. Always observe the
safety instructions in the respective documentation.
See the associated documentation for information on the application areas for the respective
components.
As the manufacturer, Bosch Rexroth does not grant any warranty, assume any liability, or provide
compensation for damages caused by improper programming or configuration of the tightening system.
The user is solely responsible for risks caused by programming and configuration of the tightening system.
Only accessories and add-on units that have been approved for use in Rexroth tightening systems may
be used therein. Non-approved components may neither be added nor connected to the system. The
same applies to cables and lines which belong to the Rexroth tightening system. Otherwise, functional
and system safety is jeopardized.
The Compact System CS351 is not designed to be directly connected to the public low-voltage power
supply, but is only intended for use in industrial environments (emission classA).
To Next Page
Loading...
