542/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
In the following cases, the connection is not cancelled automatically:
• You are currently active, i.e. you exchange data with the hardware (retrieve or transmit data). This
includes e. g.:
– Transmission of channel configurations, tightening programs or applications to the hardware
– Logon to the system, see figure 7–11
– Reading of available tightening programs or -applications from the hardware
– Query of diagnosis data
• You have opened one of the following views in the BS350:
– Actual value …
–Graph…
–Graph Save…
–Graph Overlay…
In these cases, the connection is not automatically disconnected after 15 minutes as between the
BS350 and KE/CS351 keep alive messages are transmitted on a permanent basis. This is also the
case if no configuration or tightening results data is transmitted.
7.4 Sending and saving
7.4.1 Sending files
Prerequisites for sending files:
• a connection of the PC to the tightening controller with set-up interfaces (see Setting up the
programming interface (page 539))
Prerequisites for sending files:
• In single-channel operation: a connection between the PC and CS with set-up interfaces
• In multi-channel operation: a connection between the PC and KE with set-up interfaces
and
• password entry in the BS350 (see Logging in to the tightening system (password entry) (page 541))
The following files, among others, can be sent to the controller:
• to SE/CS:
– One or more tightening programs for this tightening controller
– Tightening channel configuration
– SE/CS PLC assignment table
•to KE:
– One or more tightening applications
– KE configuration
– KE PLC assignment table
– One or more tightening programs for one or more SEs
– The tightening channel configuration to one or more SEs
– PLC assignment table to one or more SEs
The data is sent by:
• Data Send ... or
• Data Send to ... or
To Next Page
Loading...
