Bosch Rexroth Tightening System 350 - Ethernet communication

214/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.2 Ethernet communication
This chapter describes how to use the data exchange between tightening controller and partner
controller/archiving system via the FTP protocol.
This protocol can be used to transfer Identification codes (page 200) to the tightening system and to
output tightening results from the tightening system to external controllers.
• Fundamentals of the Ethernet tightening data output (page 215)
• Results output via FTP (page 220)
• Formats of the results output (page 225)
• Opening and closing the FTP connections for results output (page 240)
• Results data transfer with Ethernet (page 241)
• Initial operation of the Ethernet connection (page 246)
• Mass storage diagnosis (page 252)
• Error messages in connection with Ethernet/FTP (page 258)
Examples for tightening systems with data output via Ethernet
The following Figure illustrates a tightening system with spindles and tightening results output via
Ethernet.
Fig. 6–5: Tightening system with 17 channels, installed in BT356, e. g. in control cabinet
(1) Ethernet
(2) PLC