Bosch Rexroth Tightening System 350 - Use of Additional Components (Accessories)

3 608 878 300 Tightening Technology | Bosch Rexroth AG 109/641
System 350 | 3 608 878 300/2019-03
Work sequence for the rework station
1. Select tightening program appropriate for workpiece
2. Position nutrunner
3. Start
4. After the end of the tightening (OK/NOK display), remove the nutrunner
4.3.8 Use of additional components (accessories)
Rexroth supports you with a wide range of accessories and customized solutions for all tightening tasks.
Accessories for tightening spindles and ErgoSpin
• Torque supports
• Handling devices with torque support
• Worker guides
• Balancers
Accessories for tightening spindles
• Angle heads for size 5
• Angle heads with counter bracket
• Block output drives
• Feed clamps
• Suspensions
• Telescopic balancers
• Fully automatic tightening stations
Accessories for ErgoSpin
• Holders for right-angle nutrunners and straight nutrunners
• Holders for ESM pistol grip nutrunner
• Turning suspensions
• Suspensions for ESM ErgoSpin pistol grip nutrunners
• Extensions
• Turning suspensions for ErgoSpin with extension
• Vertical suspensions
• Start lever extensions
• Stroke extensions
• Adapters for handling devices
• Mounting aids for angle heads
• ErgoSpin with integrated scanner, see „Optional additional module barcode scanner“ on page 48
• Planetary gearboxes for high torques up to 100, 300, and 600 Nm
• Angle heads for torques above 220 Nm
Accessories for ErgoSpin VarioLine
• Angle heads
• Angle heads for special output drives
• Straight output drives
• Output drive adapters