606/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.6.5 Defining the tightening program
Proceed as listed in section Defining the tightening program (page 606) to generate a tightening program
for tightening and loosening a bolt. The generated tightening program has to be sent to all the tightening
channels involved in the tightening application. It can also be stored as a file on the PC (see Sending and
saving (page 542)).
Then test the function of the tightening program in each tightening channel with a sequence test (see
Sequence test (page 610)).
7.6.6 Defining a tightening application
1to 40 tightening positions can be coordinated within a tightening application.
Basic commissioning is carried out with a small-scale tightening application. It consists of a:
•Start step
and
• End step
The following describes how to generate a tightening application for tightening and loosening bolts.
7.6.6.1 Tightening application for tightening bolts
The tightening application for tightening bolts simultaneously starts the selected tightening spindles
clockwise along with the corresponding tightening program. The following example shows all the steps
this requires.
Please find information on the commissioning of the Nexo cordless Wi-Fi nutrunner and on the definition
of tightening programs in the "Nexo" documentation.
To Next Page
Loading...
