Bosch Rexroth Tightening System 350 - Page 607

3 608 878 300 Tightening Technology | Bosch Rexroth AG 607/641
System 350 | 3 608 878 300/2019-03
Example 1. To generate a tightening application, select File New Tightening applications in the BS350
menu bar.
2. Select an application number, e.g. 1 and assign a name to the tightening application, e.g. Test
application, by overwriting the existing program name “n.a." (not available). (If program number 0
is selected, "n.a." is not displayed).
3. Click Application info and enter a comment for the tightening application in the Application info
dialog.
4. Confirm your comment with OK.
 The Application info dialog closes and the text Application info is underlined. Move the mouse
over the button and the comment is displayed as a tooltip.
Fig. 7–33: Tightening application for the sequence test
5. Double click the start step symbol 1, A. The start step dialog opens.
6. Assign a Step name, e.g. start step.
7. Enter the name of the first tightening position in the field Name of tightening position e.g.
tightening position 1.
8. From the Channel selection list select the channel that is to be used in the tightening application
e.g. 0.1.
9. Select the tightening program (program no.) to be executed in the application from the Program
selection list.
10. Click Insert, to insert these data into the Assignment table.
11. Repeat steps 7-10 until the desired number of tightening positions is reached.
 The tightening channels transferred to the Assignment table field are started simultaneously
with the assigned tightening program in application 1.
12. If you wish to delete an entry from the Assignment table, select the entry, then click Delete.
13. If you want to change an entry, first select the entry in the assignment table and then click Change.
The entry may then be edited in the fields Name of tightening position, Channel selection and
Program selection.
14. Select Accept to save these data to the tightening application.