Bosch Rexroth Tightening System 350 - Data services

6 Data services
This chapter describes the basic principles and the application of the various data
services which can be used for data output or for data exchange with a partner
controller.
• Overview of the tightening results communication (page 196)
• Ethernet communication (page 214)
• 3964R communication (page 259)
• PLC communication (page 288)
• Printer-communication (page 316)
• ToolsNet communication (page 324)
• Rexroth Open Protocol (page 330)
• HTTP Protocol (page 434)
• VW-XML 2.x Protocol (page 445)
• Rexroth IPM Protocol (page 454)
• Field bus customer protocols (page 468)
• PLUS Protocol connection (page 472)
• QDA protocol (page 500)
• PFCS 2-Port (page 511)
• Integra-XML Protocol (page 515)
The Tightening System 350 contains customer-specific data protocols that may not be used by all
customers for legal reasons. Therefore, they are no general part of the scope of delivery of the Tightening
System350. The receivers of these customer-specific data protocols are not provided by Bosch Rexroth.
For information about the data services that can be used with the Nexo cordless Wi-Fi nutrunner, please
refer to the "Nexo" documentation.