550/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
7.5.2 Online configuration
The advantage of online configuration is that configuration and parameter assignment of components with
an electronic nameplate are automatically recognized.
7.5.2.1 Loading the tightening channel configuration
The PC and tightening channel must be connected before the online configuration can be loaded (see
Connecting the PC for programming (page 536)).
To load the current configuration of the tightening channel:
Click System Tightening channel configuration or .
System components with an electronic nameplate are automatically recognized by the BS350 and listed
with the appropriate information,e.g.:
• ErgoSpin
•EC-motor
• Measurement transducer
• Interface Modules
• Part no.
• Firmware version
• Battery monitoring
• Monitoring of the compact flash card
To check the configuration of the interfaces:
1. Double click the field
All the available interfaces are displayed. The X3C1 serial interface and the X7E1 Ethernet
interface are permanently installed. The other interfaces are not equipped
1)
.
All the interface fields are closed by double clicking again.
Configuration of a tightening channel with ErgoSpin SlimLine and ErgoSpin GripLine is implemented
automatically. You do not have to supplement the configuration. For further information on the automatic
configuration of an ErgoSpin tightening channel, see Configuring the tightening channel (page 617).
1) For possible interface assignments and parameterizations, see Setting up additional interfaces
(page 561).
To Next Page
Loading...
