3 608 878 300 Tightening Technology | Bosch Rexroth AG 551/641
System 350 | 3 608 878 300/2019-03
Fig. 7–14: View of the interfaces in the compact system
7.5.2.2 Completing the tightening channel configuration
To delete a component:
Click the appropriate symbol in the configuration sequence and press the [Del] button to delete the
component.
To add a component:
Add a permitted component (displayed in black) (see page 576).
A distinction is made between two cases:
– If the new component is to be added to an empty field then select the empty symbol field in
the configuration sequence and add a permitted component (=displayed in black) from the
component selection into the configuration sequence.
– If the new component is to be inserted between two components, then select the component
in the configuration sequence in front of which you wish to insert a new element. Then, insert a
component permitted (=displayed in black) within the configuration sequence.
Configuration with standard version
If the tightening channel only contains mechanical components, e.g. an additional drive component on the
ErgoSpinVarioLine, they are inserted in the configuration sequence, but not parameterized. They are
therefore highlighted in red and the message Check component ______ Set parameters is displayed.
The same applies for a compact system with tightening spindle (see 7–15). Here, the EC-motor and the
measurement transducer are recognized automatically due to their electronical nameplates, whereas the
mechanical components, e.g. planetary gearbox and straight output drive, have to be parameterized
manually.
NOTICE
Incorrect channel configuration
An incorrectly configured ErgoSpin VarioLine or pistolgrip nutrunner may result in faulty tightenings.
When working with the ErgoSpin VarioLine or pistolgrip nutrunner, always check that the
components stored on the hand-held nutrunner correspond to the actually equipped
components and, if necessary, correct the configuration with the operating program.
To Next Page
Loading...
