Bosch Rexroth Tightening System 350 - Saving Data

3 608 878 300 Tightening Technology | Bosch Rexroth AG 543/641
System 350 | 3 608 878 300/2019-03
7.4.1.1 Send ...
Single-channel
operation (CS)
Files loaded online can be edited and then sent to the tightening controller using Data  Send ... .
Amongst others, these files include:
• Tightening program
• Tightening channel configuration
• SE/CS PLC assignment table
Multi-channel
operation (KE)
Files loaded online have to be sent to the KE after editing. Amongst others, these files include:
• Tightening program
• Tightening channel configuration
• KE PLC assignment table
The KE forwards tightening programs and tightening channel configurations to the SEs.
7.4.1.2 Send to …
Single-channel
operation (CS)
Files loaded online or created offline can be sent to the tightening controller with Data  Send to ... .
Amongst others, these files include:
• One tightening program or several tightening programs simultaneously
• Tightening channel configuration
• SE/CS PLC assignment table
Multi-channel
operation (KE)
Files loaded online or created offline have to be sent to one/several SEs or the KE. Amongst others, these
files include:
• One or more tightening programs to one or more SEs
• The tightening channel configuration to one or more SEs
• The SE PLC assignment table to one or more SEs
• One or more tightening applications to the KE
7.4.2 Saving data
File  Save
An open and modified file is saved with the same name using File  Save.
Files created offline cannot be sent using Data  Send ... or . For this purpose, use Data  Send
to ... or
.
Files created offline for the KE cannot be sent to a tightening channel using Data  Send or . For
this purpose, use Data  Send to ... or .
The KE configuration and KE PLC assignment table cannot be sent using Data  Send to ... or clicking
! For this purpose, use Data  Send ... or
.