3 608 878 300 Tightening Technology | Bosch Rexroth AG 579/641
System 350 | 3 608 878 300/2019-03
6. Select the end step and click the symbol .
A single tightening step is added before the end step (see Figure 7–24).
Fig. 7–24: Loosening program for the sequence test
7. Double click the new tightening step symbol.
The parameter dialog for the tightening step appears (see Figure 7–24).
8. Enter the following data:
Name, e.g. Loosen
Target function, e.g. Angle, value: 200 [°]
Additional functions, e.g. Speed, value: -100 rpm.
9. Click Accept to store these data in the tightening program.
The following entered data have to be adapted to the respective tightening channel configuration. The
max. speed, which can be seen in the Spindle limits field in the configuration window of the tightening
channel (see Figure 7–16), must not be exceeded.
Always enter a negative speed value for counterclockwise rotation.
To Next Page
Loading...
