3 608 878 300 Tightening Technology | Bosch Rexroth AG 553/641
System 350 | 3 608 878 300/2019-03
Fig. 7–16: Completing the configuration with the special component entry window
2. Select the component to be used from the Code drop-down list (note the sizes).
3. A serial number does not need to be entered for mechanical components.
4. Efficiency is used to calculate the torque of the output drive. Nominal efficiency is automatically
entered for the corresponding component by the BS350, but it can be adjusted up or down as
needed (e.g. if there are signs of wear). The values in the grayed-out windows cannot be modified.
5. Click Accept to accept the component data into the program. The data are then displayed in white.
The assignment of parameters is aborted and any modifications are rejected by selecting Cancel.
6. If necessary, set the missing parameters for further components.
Alternatively, you can also delete the component (see above). You then add another, side-by-side
component such as an angle head or adapter on tightening spindle output drives, for the
ErgoSpinVarioLine. Also set the missing parameters for this component as described above.
Compare all the values in the parameter fields to the data on the name plates for accuracy. To correct
these values, double click the respective parameter field, then correct and transfer the data to the
configuration.
To Next Page
Loading...
