554/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
ErgoSpin configuration without standard version
Additional, special mechanical components can be added to the ErgoSpin ESM and ESV hand-held
nutrunners. After you have added them, the components can be selected from the database or freely
configured.
1. If necessary, delete an existing component.
2. Add a new component.
3. Double click the field highlighted in red to open the associated parameter dialog.
4. Figure 7–17 shows the Special component dialog after double clicking the line SO.
Fig. 7–17: Completing the configuration with the special component entry window
5. Enter the order number for the special component into the Order number list field.
A serial number does not need to be entered for mechanical components.
Enter the efficiency of the special component into the Efficiency list field.
6. Enter the transmission for the special component into the Transmission list field.
For monitoring purposes, you can also enter the maximum permissible torque for the special
component.
7. Click Accept to accept the planetary gearbox data in the program. The data are then displayed in
white.
The assignment of parameters is aborted and any modifications are rejected by selecting Cancel.
To Next Page
Loading...
