244/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.2.5.3 Results transfer before process end of a single-channel tightening
Fig. 6–19: Chronological sequence for processing and transferring tightening results for a single-channel tightening via FTP
protocol
Here, the actual end of the tightening process is also indicated by the evaluation signals (CH x.y Ok,
CH x.y Nok) switching from L to H. At this point, the tightening spindle can be removed from the
processed component.
(A) Single-channel tightening
(B) Transfer via FTP
Ch x.y CyCmp Process end
Ch x.y Ok Evaluation
Ch x.y ResRs Result reset
(1) Cycle (single-channel cycle)
(2) Sequence
(3) Result processing
In version 2.1 and below, the results output is not necessarily completed after a process end for single-
channel tightening.
To Next Page
Loading...
