3 608 878 300 Tightening Technology | Bosch Rexroth AG 473/641
System 350 | 3 608 878 300/2019-03
6.12.2.1 Scan and Work (SaW)
1. The component arrives at a station. The identifier is read manually via a bar code or applied by a data
carrier that is carried along.
2. An activity pattern inquiry is sent to the PLUS server based on the identifier.
3. The PLUS server supplies the appropriate activity pattern and, if necessary, the changed identifier to
the station which converts it into tightening processes with the associated program selection. The
tools of the station are released and machining of the workpiece starts.
4. After the workpiece has been machined, the station summarizes the machining results for the
workpiece and transmits them to the PLUS server.
Component,
data carrier
Tightening System
350
PLUS-server
2. Request: Activity pattern due to identifier
3. Send: Activity pattern, identifier changed, if necessary
4. Send: Production and quality data (PQD)
1. Read identifier
To Next Page
Loading...
