546/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
Fig. 7–12: Parameters dialog for configuration of the backup/restore function
Auto backup/restore function
Configuration and firmware of the components are stored on the CF350 of the respective
component according to the settings in the
Auto backup/restore dialog. If the configuration or
firmware changes, this data is updated on the CF350. If the CF350 is connected to a different
1 When logging off
2Time 1
3Time 2
4Time 3
5 By "Backup" PLC signal
6 Auto restore
7 Start restore manually
8 Start backup manually
Table 7–11: Settings in the Backup/Restore function configuration
Element Description
When logging off If the When logging off option is enabled, the backup function is
started automatically after the user is logged off from the BS350
Tightening System.
Time 1
Time 2
Time 3
If the option Time 1, Time 2 or Time 3 is enabled, the automatic
backup is started automatically after the selected time(s). If a user
is logged in at the tightening system, the automatic backup function
is started if the user is logged off.
By "Backup" PLC signal If the By "Backup" PLC signal option is enabled, the automatic
backup function is started if the Backup PLC signal changes from
0 to 1. If a user is logged in at the tightening system, the automatic
backup function is started if the user is logged off.
Auto restore If the Auto restore option is enabled, the stored backup is loaded
automatically after replacement of a defective component.
Start restore manually The Start restore manually button enables manual starting of the
restore function.
Start backup manually The Start backup manually button enables manual starting of the
backup function.
To Next Page
Loading...
