EasyManua.ls Logo

Bosch Rexroth Tightening System 350 - Page 631

Bosch Rexroth Tightening System 350
641 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 608 878 300 Tightening Technology | Bosch Rexroth AG 631/641
System 350 | 3 608 878 300/2019-03
Angle compensation is activated by means of a license available on a license stick. Each license stick
contains exactly one license for one tightening channel. For licensing, the license stick can be inserted
into the following slots:
At the control unit (SE), the license stick is inserted in the respective channel for the nutrunner in slot
X3U1 or X3U2 and the channel is assigned in the channel configuration.
At the CS351 compact system, the license stick is inserted into slot X3U1 or X3U2.
On switching on the system, the availability of valid licenses is checked. An overview of the licenses per
channel can be accessed in menu System test Tightening cell info Licenses. If the system
recognizes, that a license cannot be read, a buffer period (up to 10 days) is activated. This buffer period
is displayed in menu System test Tightening cell info Licenses. During this period, the function
has to be deactivated or a valid license inserted.
Free demo period Angle compensation can be tested for up to 30 days without a license. It can only be activated once for
each channel at each controller. It is activated by means of the channel configuration:
Online: System Tightening channel configuration CS or SE
The additional function enables activation or deactivation of the 30-day demo period with the Angle
compensation demo period checkbox. The checkbox cannot be enabled if the demo period was already
activated or has expired. The license overview shows the remaining runtime. If the period has expired, a
respective error message (FC 3007) is returned.
If the angle head output drive axis is not aligned with the tightening axis, an angle head compensation
error occurs. A deviation of 15° leads to an error of approx. 1.5°.
Fig. 7–48: Angle head output drive axis of the ErgoSpin hand-held nutrunner and tightening axis
Tightening axis
Angle head output drive axis
Only connect the license stick in de-energized condition.

Table of Contents

Related product manuals