When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi indicator lights up.
Wait approximately 2 minutes until the IP address settings of the machine are completed.
IMPORTANT:
Signal strength
When more than one wireless router is available for connection, the machine connects to the device with the strongest signal.
Signal strength is measured using RSSI (Received Signal Strength Indication).
NOTE
Reducing power consumption
You
can
set the
machine to
enter
<Power
Save
Mode>
based
on
signals emitted
from
the
wireless
router.
Power Save ModeIf the IP address of the machine has changed
In a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is
maintained as long as the machine and the computer belong to the same subnet.
LINKS
Connecting to a Wireless LAN (MF8580Cdw / MF8280Cw Only)
㻟㻞㻣㻌㻛㻌㻢㻣㻢
To Next Page
Loading...
