0ALJ-07X
Setting Up Connection Using WPS Push Button Mode
If your wireless router supports WPS push button mode, you can easily set up a connection with a WPS button.
IMPORTANT
How to operate the wireless router may vary on each device. See the instruction manuals for your networking device for help.
Press .
Use / to select <Network Settings>, and press .
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the
Machine
Select <Wireless LAN Settings>, and press .
If the <Do you want to enable the wireless LAN?> message is displayed, select <Yes>, and press .
Read the message that is displayed, and press .
Select <WPS Push Button Mode>, and press .
Select <Yes>, and press .
Press and hold the WPS button on the wireless router.
The button must be pressed within 2 minutes after pressing in step 6.
Depending on the networking device, you may need to press and hold the button for 2 seconds or longer. See the instruction
manuals for your networking device for help.
NOTE:
If an error message is displayed during setup
Press
and return to step 5.
Check that the Wi-Fi indicator is blinking on the operation panel.
The Wi-Fi indicator blinks when a wireless router is detected.
1
2
3
4
5
6
7
8
㻟㻞㻢㻌㻛㻌㻢㻣㻢
To Next Page
Loading...
