server. When [Use] or [Use (Security Authentication)] is selected, the user name and password must be specified.
[Do Not Use] Select not to authenticate the machine using the login information.
[Use] Select to authenticate the machine using the login information.
[Use (Security
Authentication)]
Select to use data obtained by Kerberos, a network authentication protocol, for the authentication
password. If this setting is selected, the clock of the machine needs to be synchronized with that of the
LDAP server.
[User Name]
Enter the user name of the machine that was registered to the LDAP server. Depending on the type of characters used, up to 120
characters can be entered.
When [Use] is selected for [Login Information], enter the user name in the form "(domain name)\(user name)" (example:
domain1\user1).
When [Use (Security Authentication)] is selected, enter the user name only (example: user1).
[Set/Change Password]
To specify or change the password, select the check box and enter up to 24 characters in the [Password] text box.
[Domain Name]
When [Use (Security Authentication)] is selected for [Login Information], enter up to 120 alphanumeric characters for the
directory tree name in Active Directory (example: example.com).
[Display Authentication Screen When Searching]
Select the check box to require the user to enter the user name and password when a search is requested. If the check box is
cleared, entries in the [User Name] and the [Password] text boxes are used for authentication.
Click [OK].
LINKS
Specifying Destinations in an LDAP Server (Fax)
Specifying Destinations in an LDAP Server (E-mail)
Configuring SNTP
6
㻟㻤㻡㻌㻛㻌㻢㻣㻢
To Next Page
Loading...
