Cisco D9887B - Input B

Dual Input COFDM Receiver Option
78-4043743-01 Rev A 83
Spectrum A
1 Use the Up and Down buttons to move the cursor to "Spectrum," then press the
Enter button.
2 Use the Up and Down buttons to change the spectrum ("Normal", "Inverted"),
then press the Enter button to save the selection.
Input B
These settings correspond to the input on "Source B."
Center Frequency B
The COFDM card tunes to the center frequency of the channel to tune to.
1 Use the Up and Down buttons to move the cursor to "Center Freq," then press
the Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the center frequency (49 MHz – 861 MHz), then press
the Enter button to save the selection.
Channel Bandwidth B
1 Use the Up and Down buttons to move the cursor to "Channel BW," then press
the Enter button.
2 Use the Up and Down buttons to change the channel bandwidth ("6 MHz", "7
MHz", "8 MHz"), then press the Enter button to save the selection.