3 Use the Up and Down buttons to move the cursor to "Sdi Aud Embed," then
press the Enter button.
4 The current settings are displayed. Press the Enter button again to edit the
settings.
5 Use the Up and Down buttons to move the cursor to the pair location for the
embedded audio, Group 1 "Pr1" or "Pr2", and Group 2 "Pr1" or "Pr2," then press
the Enter button to edit the assigned audio.
6 Use the Up and Down buttons to select the audio that is assigned to the pair,
"Off", "Aud 1 PCM", Aud 1 Dig. Pass", "Aud 2 PCM", or "Aud 2 Dig. Pass." If an
Audio Output (Dolby E, AES Digital, Analog) option card is installed in the RDS,
"DolbyE" is an additional audio option. Press the Enter button to save the
selection.
Audio 1 Setup
The following menus are used to setup the audio downmix settings.
Note: Refer to Appendix E - D9887B Receiver Audio Explanation (on page 241) for
the D9887B receiver Audio Explanation.
Note: These settings do not apply to Dolby E audio.
Use the following instructions to setup Audio 1-4 (if equipped).
1 Use the Up and Down buttons to move the cursor to "Audio 1 Setup," then press
the Enter button.
2 The current screen shows the status of the audio downmix settings. Press the
Enter button again to display the Edit screen.
To Next Page
Loading...
Need help?
General
