Cisco D9887B - RW Community Setup

SNMP Configuration
78-4043743-01 Rev A 159
RW Community Setup
To change the RW Community, follow the steps below:
Use the Up and Down buttons to move the cursor to "RW Community," then press
the Enter button.
Name
1 Use the Up and Down buttons to select "Name," then press the Enter button.
2 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the Name, then press the Enter button to save the
selection.
Connection 1
1 Use the Up and Down buttons to select "Ip1," then press the Enter button.
2 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the IP address, then press the Enter button to save the
selection.
3 Use the Up and Down buttons to select "Port1," then press the Enter button.
4 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the Port1 value, then press the Enter button to save the
selection.