Cisco D9887B - Page 184

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
160 78-4043743-01 Rev A
Connection 2
1 Use the Up and Down buttons to select "Ip2," then press the Enter button.
2 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the IP address, then press the Enter button to save the
selection.
3 Use the Up and Down buttons to select "Port2," then press the Enter button.
4 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the Port 2 value, then press the Enter button to save the
selection.