Note: The symbol "♦" denotes that the PID is a selected PID (being sent to the
CAM). The symbol "â—Š" denotes that the PID is not selected (not being sent to the
CAM).
PIDs No Longer in the Input PMT
The selected PIDs that are not listed in the PMT are listed followed with a "*" under
the associated CAM. The list contains the Services, with PID selection available after
selecting the Service. These PIDs can be selected or deselected. If they remain
selected and appear in the PMT, those PIDs will be sent to the CAM for decryption.
1 Use the Left and Right buttons to move the cursor to a "*"’ed Service, then press
the Enter button.
2 Use the Up and Down buttons to move the cursor to the PID to be selected or
deselected, then press the Enter button.
3 Use the Up and Down buttons to change the selection status.
4 Press the Enter button to save the selection.
5 The display will return to the PID selection list (Step 3) with the correct "♦" or "◊."
Note: When the Service no longer has PIDs that are not in the PMT, it will not be
listed as a "*"’ed Service.
BISS Setup
To setup the D9887B receiver to be able to decrypt a BISS encrypted transport stream
use the following steps:
1 Press the Home button to bring the display back to the RDS status screen.
2 Press the Left button to access the RDS 1 Decoder Menu.
To Next Page
Loading...
Need help?
General
