EasyManuals Logo

Cisco D9887B User Manual

Cisco D9887B
290 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
102 78-4043743-01 Rev A
Setting when to Restore to the Primary
Note: This is not changeable when using "TrigDecErr" ("Pri Rest" is set to "Never" in
this case).
1 Use the Up and Down buttons to move the cursor to "Pri Rest," then press the
Enter button.
2 Use the Up and Down buttons to select "Never", "WhnPriRet" (When the
Primary Returns), or "OnBkpFail" (On Backup Failure), then press the Enter
button to save the selection.
Setting the Switchover Timeout
The Switchover Timeout is the delay between the detection of the failure and the
switch to either the backup or back to the primary (controlled by the Restore to
Primary setting) receive group.
1 Use the Up and Down buttons to move the cursor to "Timeout," then press the
Enter button.
2 Use the Up and Down buttons to select the time in seconds (from 0 to 10 seconds
in 0.5 second intervals), then press the Enter button to save the selection.
Receive 1
This section allows the user to setup the receive function of the first receive group.
1 Use the Up and Down buttons to move the cursor to "Receive 1," then press the
Enter button.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco D9887B and is the answer not in the manual?

Cisco D9887B Specifications

General IconGeneral
BrandCisco
ModelD9887B
CategoryReceiver
LanguageEnglish

Related product manuals