Cisco D9887B - Page 127

Dual MPEG over IP Input/ UDP Output Option
78-4043743-01 Rev A 103
2 Use the Up and Down buttons to move the cursor to "Receive," then press the
Enter button.
3 Use the Up and Down buttons to "Enable" or "Disable" Receive 1, then press the
Enter button to save the selection.
4 Use the Up and Down buttons to move the cursor to "Phys Conn," then press the
Enter button.
5 Choose the physical connector using the Up and Down buttons ("Port 1" or "Port
2"), then press the Enter button.
IP
1 Use the Up and Down buttons to move the cursor to "IP," then press the Enter
button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the IP, then press the Enter button to save the selection.
Note: A Unicast or Multicast IP address may be chosen.
Unicast: X.X.X.X – 223.255.255.255
Multicast: 224.0.0.0 – 239.255.255.255
Suggested Multicast Range: 239.192.X.X
Destination Port
1 Use the Up and Down buttons to move the cursor to "Dest Port," then press the
Enter button.