Cisco D9887B - Overlay (Table)

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
38 78-4043743-01 Rev A
Overlay (Table)
Note: This menu changes depending on which overlay is set in "Overlay."
1 Use the Up and Down buttons to move the cursor to "Overlay," then press the
Enter button.
2 Use the Up and Down buttons to select the appropriate type of overlay ("PSI
PAT", "PSI PMT", "ATSC MGT", "ATSC STT", "ATSC TVCT", "ATSC EIT", "ATSC
EPG"), then press the Enter button to save the selection.
Screen Interaction
This mode allows the user to page through the on-screen PSI/ATSC tables.
Note: This option is only available if the type of overlay is set to "Table."
1 Use the Up and Down buttons to move the cursor to "Screen Interaction," then
press the Enter button.
2 While this mode is enabled, the Up, Down, Left, and Right buttons will control
the on-screen PSI/ATSC tables. To exit the "Screen Interaction" mode, press the
Exit button.
Coordinated Universal Time Offset
1 Use the Up and Down buttons to move the cursor to "Utc Offset," then press the
Enter button.
2 Use the Up and Down buttons to change to the appropriate offset, then press the
Enter button to save the selection.
Note: The UTC values and their offsets are listed in Appendix D - Coordinated
Universal Time (on page 237).