Video Output (2 HD/SD-SDI, 1 RGBHV/YPbPr/Composite) Option
A versatile video output card. It provides two user selectable serial digital (SMPTE-
259M, or SMPTE-292M) outputs and one component RGBHV or YPbPr/Composite
NTSC & PAL output. Four pairs of audio can be embedded into the serial output on
group 1, and 2. Closed captioning found within the transport (608/708B) can be
embedded into the serial video output. NTSC closed caption, detected in the
transport stream, can be inserted on line 21.
Dual Input DVB-S/DVB-S2 Receiver Option
This card will input a satellite L-band (950 MHz – 2150 MHz) signal for
demodulation of KU-band or C-band DVB-S QPSK signals or DVB-S2 QPSK/8PSK
signals. The symbol rate ranges from 1 MSym/s to 45 MSym/s for DVB-S and 1-30
MSym/s for DVB-S2. This card does not provide any power to the dish LNB. The
"Input" LED will only illuminate if the card detects frequency, symbol rate, FEC lock
(Carrier Lock), and TS sync (Sync Lock). The card provides A and B inputs, which
may be independently configured, but only one may be active at a time.
Dual Input ASM Receiver Option
This card will input a satellite L-band (950 MHz – 2150 MHz) signal for
demodulation of KU-band, C-band, or X-band DVB-QPSK, 8PSK, or Adv-QPSK
signals. All these modes are available using Turbo Coded forward error correction.
The DVB-QPSK mode also supports legacy DVB FEC. The symbol rate ranges from
0.256 MSym/s to 30 MSym/s for all modulation types. This card does not provide
any power to the dish LNB. The "Input" LED will only illuminate if the card detects
frequency, symbol rate, FEC lock (Carrier Lock), and TS sync (Sync Lock). The card
provides A and B inputs, which may be independently configured, but only one may
be active at a time.
Video Output (2 HD/SD-SDI, 1 RGBHV/YPbPr/Comp) Option
A versatile video output card. It provides two user selectable serial digital (SMPTE
259M, or SMPTE 292M) outputs and one component RGBHV or YPbPr/Composite
NTSC & PAL output. Eight pairs of audio can be embedded into the serial output on
group 1, 2, 3 and 4. Closed captioning found within the transport (608/708B) can be
embedded into the serial video output. NTSC closed caption, detected in the
transport stream, can be inserted on line 21.
Note: This card requires the MPEG Decoder with Genlock (1 Video, 4 Audio) board.
To Next Page
Loading...
